100W Polycrystalline Solar Panel

Description

Polycrystalline silicon solar module with the highest power available for 12V panel. Particularly suitable for systems with accumulators (huts, campers, lighting, industrial uses, etc.), thanks to the voltage suitable for charging 12V batteries.

This 100W 12V Solar Panel is made of tempered anti-hail glass, with Polycrystalline silicon cells of Grade “A” encapsulated in EVA and covered with waterproof film that makes the panels resistant to bad weather and therefore suitable for outdoor use. The Anodized Aluminum frame makes it even more rigid and easy to fix on various support structures.

Why Choose NX Solar Solar Panels

• Long useful life of the modules
• “Grade A” Photovoltaic Cells, compared to other non-Grade A modules on the market.
• Low iron glass, maximum sunlight absorption, and low reflectivity
• Low percentage of loss per degree centigrade, in fact its loss with heat is very low compared to the average of the modules on the market.
• Average annual production, higher than average. Panels with CE certification.
• These modules are PV Cycle certified for free module disposal.
• Certified IEC 61215, IEC 61730 by TUV and ISO 9001.

Power warranty =80%25 years

Product warranty: 2 years

Dimensions 94.5 x 67 x 3 cm

Weight Kg 7

Technical Features

Cell Type: Polycrystalline

Panel Height (cm): 94.50

Panel Width (cm): 67

Panel Thickness (cm): 3

Panel Weight (kg): 8 kg

Short circuit current (Isc): 5.60 A

Open circuit voltage (Voc): 22.68 V

Voltage at maximum power point (Vmp): 19.12 V

Current at maximum power point (Imp): 5.23 A

Module efficiency: 15.2%

NOCT (Nominal operating cell temperature): 43°C +/-2

Voltage variation with temperature (ß): -0.35%/°C

Operating and maintenance temperature: from -40 to +85 °C

Maximum system voltage: 1000 V

Connectors: MC4 compatible

Peak power (Wp): 100W

The panel is equipped with two cables of about 70 cm in length (one positive and one negative) headed with two  MC4 multicontact connectors . The connectors are used to connect multiple panels in series with each other and/or to connect the extension that connects the panel to the charge regulator. In the latter case, you can proceed in two ways:

1) cut the connectors, and connect the remaining piece of cable (if sufficient) directly into the charge controller, or add another piece of cable of the length I want, by soldering.

2) connect another cable with the respective connectors  (see accessories below)  on one of the two ends, in order to obtain a safer, faster connection, which can also be disconnected and reconnected more easily.